1. The first possible cause of tool jumping failure is the problem of the engraving machine limit system. The limit system is usually used to prevent offside caused by operating errors, thereby protecting the spindle and guide rails from human damage. If the operator is experienced, you can consider temporarily shielding the limit signal to avoid interference between the limit signal and the spindle inverter signal. The limit signal is usually controlled by the 5-volt drive impulse voltage on the control card, and you can try to remove the voltage to solve the problem.
2. The second part to check is the control card. If a tool jumping failure occurs, you can try to re-plug the control card and data cable to see if the problem can be solved. If this does not work, you can try to reinstall the operating software system.
3. If the problem persists after re-plugging the control card, you need to check the three-axis drive of the engraving machine. The drive motor line may have poor contact or breakage due to the dragging of the spindle during processing, resulting in the lack of phase of the drive motor, resulting in the phenomenon of spindle tool jumping during processing. Check the drive motor wiring to ensure that there is no fault.
4. Finally, check if the mechanical structure of the spindle is loose, such as loose screws or loose couplings. Although this may not be the main cause, loose screws will cause the spindle to vibrate more when rotating, which may cause tool breakage. Regular inspections can detect and prevent such problems in advance.
Causes Of Tool Jumping Failure in CNC Equipment ''woodworking Engraving Machine''
Oct 14, 2024
Send Inquiry
Latest News










